Table of Contents
Advertisement
44
Installing a 5.25-inch storage device (optional)
Note: If you are installing a new drive in an empty drive bay, skip
steps 2 to 4.
1
Observe the ESD precautions and pre-installation procedures
described on page 31.
2
Disconnect the power and IDE cables from the old drive.
3
Press the release bracket on both sides of the drive carrier (1)
before pulling it out from the chassis (2).
4
Remove the eight screws that hold the old drive to the drive
carrier then pull it out.
3 Upgrading the system
Advertisement
Table of Contents
