Installing And Removing An Optical Drive - Acer Altos R520 M2 Series User Manual

Installing and removing an optical drive

Note: The optical drive is not hot-pluggable. Before removing or
replacing the drive, you must first power down the server, unplug
the AC power cord from the system, and turn off all peripherals
devices connected to the server.
To install an optical drive:
1 Perform the pre-installation instructions described on page 35.
2 Remove the front bezel. Perform the instructions described in "To
remove the front bezel" section on page 37.
3 If a filler panel is installed, remove it from the drive bay.
4 Remove the access panel and optical drive tray.
(1) Remove the four screws that secure the access panel to the
chassis.
(2) Slide the access panel to disengage from the chassis, then lift
the access panel off the chassis. Put the access panel aside for
reinstallation later.
(3) Remove the two screws that secure the optical drive tray to
the chassis.
47