Canadian Regulatory Information; Industry Canada Notice - Aastra Venture 3-Line with Answering User Manual

Canadian regulatory
information

Industry Canada Notice

The Industry Canada label identifies
certified equipment. This
certification means that the
equipment meets certain
telecommunications network
protective, operational and safety
requirements. The Department does
not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment,
users should ensure that it is
permissible to be connected to the
facilities of the local
telecommunications company. The
equipment must also be installed
using an acceptable method of
connection. The method of
connection approved for this
equipment as designated by D.O.C.
Standard CS-03 is a CA11A/CA14A
or CA11W/CA14W connection
arrangement. The A or W suffix
74 Venture 3-Line Telephone with Answering Device User Guide
indicates that either desk or wall
mounting is approved. In some cases,
the company's inside wiring
associated with a single line
individual service may be extended
by means of a certified jack-plug-
cord ensemble (telephone extension
cord). The customer should be aware
that compliance with the above
conditions may not prevent
degradation of service in some
situations.
Existing telecommunications
company requirements do not permit
their equipment to be connected to
customer provided jacks except
where specified by individual
telecommunications company tariffs.
Repairs to certified equipment
should be made by an authorized
Canadian maintenance facility
designated by the supplier. Any
repairs or alterations made by the
user to this equipment, or equipment
malfunctions, may give the
telecommunications company cause
to request the user to disconnect the
equipment.
Users should ensure for their own
protection that the electrical ground
connections of the power utility,
telephone lines and internal metallic
water pipe system, if present, are
connected together.
This precaution may be particularly
important in rural areas.
CAUTION
: Users should not attempt
to make electrical ground
connections themselves, but should
contact the appropriate electric
inspection authority, or electrician, as
appropriate.