Operation; Setting The Ringer Off/Low/Hi Switch; Setting The Tone/Pulse Switch; Making Calls - Bell BE-70PS Owner’s Owner's Manual

OPERATION

Using the Ringer Off/Low/Hi Switch
The Off/Low/Hi switch can be used to set the sound level of the ringer.
1. Set the Off/Low/Hi switch to the Hi position for normal operation.
2. Set the Off/Low/Hi switch to the Low position for less sound.
3. Set the Off/Low/Hi switch to the Off position for no sound.

Setting the Tone/Pulse Switch

Your telephone can operate in tone or pulse dialing mode.
1. Set the T/P switch to the desired position. If you're not sure which service
you have, set the T/P switch to the tone, T position. See Figure 2
2. Lift the handset and dial your number. If the dial tone continues, you have
pulse service, set the T/P switch to the pulse, P position.

Making Calls

To make a call, lift the handset or press the SPK button once.
1. When dial tone is heard, dial the desired number.
2. The handset icon as well as the number being dialed will be indicated in
the display.
3. Hang up when you finish your call. Within 10 seconds, the display will re-
turn to Stand-By Screen mode.

Receiving Calls

When the telephone rings, the RINGER LED will flash.
Important: Do not answer incoming calls until the second ring occurs.
This is necessary so that the Caller ID information can be received.
1. Lift the handset or press the SPK button once.
2. The HANDSET icon as well as the Caller-ID information will be displayed
for the duration of the call.
3. If necessary, adjust the VOLUME control located on the right side of the
telephone headset to a comfortable receive level. See Figure 2
4. Hang up when you finish your call. Within 10 seconds, the display will re-
turn to the Stand-By Screen.

Using the Speakerphone

You can make or receive calls using the speakerphone.
- 16 -
16