Wall Mounting - Bell BE-70PS Owner’s Owner's Manual

INSTALLATION - continued
4. Install the telephone wall mounting bracket to the bottom surface of the
telephone. See Figure 7
5. Plug the coiled cord into the modular jack located on the handset.
6. Plug the remaining end of the coiled cord into the handset jack located on
the left side of the telephone. Place the handset into the cradle.
7. Plug the remaining end of the short telephone cord into the telephone wall
jack. See Figure 7
8. Slide the two slots located on the wall mounting bracket over the two
mounting studs on the telephone wall jack. See Figure 8
9. Carefully press downward until the telephone is secured to the jack.

Wall mounting

If the telephone wall jack does not have a face plate containing two mounting
studs, the BE-70PS can be mounted to the wall using two self-tapping screws
(supplied). Follow the previous instructions but with the following changes.
1. Choose a mounting location for the telephone that is less than seven (7)
feet away from the telephone. See Figure 10
2. If you are mounting the wall bracket to a plaster board wall surface, it is
necessary to first drill two
anchors into the wall. See Figure 9
3. Install the two self tapping screws at a distance of 3
from each other and located on a vertical center line. See Figure 9
4. Press a plastic anchor into each of the two holes. Tap the anchor into the
wall with a hammer until the anchor is completely seated.
5. Insert a screw into each mounting hole and tighten each screw with a
screwdriver.
4. Tighten each screw just enough to allow the wall mounting bracket enough
clearance to slip snugly over each screw head. Continue to tighten the two
screws until the bracket is secure. Do not over tighten the screws.
5. Connect one end of the long telephone line cord into the TEL. LINE jack
located on the telephone.
6. Press the telephone line cord into the groove located on the back of the
telephone so that it is flush.
7. Install the telephone to wall mounting bracket, make sure that it is secure
prior to use.
8. Connect the remaining end of the telephone cord into an existing telephone
jack.
3
/ inch holes to install the two expanding plastic
16
- 14 -
14
29
/ inches (100 mm)
32