Basic Operation; Making Calls; Receiving Calls; Redialing - Bell Sonecor BE-3850 Installation And Operating Manual

BASIC OPERATION

Making Calls

1. Pick up the handset and press T.
2. Wait until you hear a dial tone and then dial the
number you wish to dial. The call timer will begin.
Tip: It is also possible to pre-dial the number, by dialing the
number prior to pressing the T key. The number
displayed will be dialed once T is pressed.
3 When you are finished talking, press the T key or
place the unit back into the base to end the call.

Receiving Calls

When you hear the phone ring:
1. The display will show "RING." If you have Caller ID,
the display will show the Caller ID information after the
first ring.
2. With the handset in or out of the base, push T. The
call timer will start.
3. When you are finished, push T or place the handset
back in the base.
19
BASIC OPERATION

Redialing

1. Press T.
2. Wait until you hear the dial tone and then press
R to redial the number last dialed (up to 32
digits).

Additional Options

To: Do This:
Adjust the volume in the earpiece Adjust the volume control switch on the right side of the
handset to the desired volume level.
Press the * key after the phone is in use. The phone will
Switch to temporary tone dialing
remain in tone dialing mode for the duration of the call.
Press F to go to the new caller.
Receive a call waiting call
Press F again to go back to the original caller.
20