Troubleshooting - Bell BE-70PS Owner’s Owner's Manual

TROUBLESHOOTING

The display screen is blank. Possible causes of the problem are:
1. The battery needs to be replaced.
No Dial Tone. Possible causes of the problem are:
1. The telephone line cord is not plugged in properly at the telephone jack or
at the telephone.
2. Test the telephone using a different telephone jack, if it works, the first jack
may be defective.
Have Dial Tone but cannot break dial tone. Possible causes of the prob-
lem are:
1 Check that the T/P switch is set to the correct mode.
Does not display Caller-ID information. Possible causes of the problem
are:
1. Confirm that your local telephone company has activated Caller-ID service.
2. Caller-ID information is sent by the telephone company between the first
and second rings. If the call is answered before the second ring, the Caller-
ID information may not be received correctly.
3. If a telephone answering machine is connected to the same phone line, it
must be set to answer in two or more rings.
Error appears in the display. Possible causes of the problem are:
1. Bad data may have been received. This may be due to a transmission or
reception error. It is recommended to erase call records that have a error
indication.
Cannot dial a call record. Possible causes of the problem are:
1. Confirm that you programmed your local area code into the telephone. If
not, reprogram the area code again.
- 24 -
24