PowerVault 130T Service Manual
DLT Drive Tray Assembly
The DLT drive tray assembly FRUs are located in the tape drive slots at the left
rear of the library. This assembly is also a CRU.
Tools required:
ESD wrist strap
Flat blade screw driver
Figure 3–5.
DLT Drive Tray Assembly
NOTE: Tape drives are hot swappable, meaning they can be removed and replaced
without powering off the library or interrupting its operations. Hot swapping
should only be performed by trained technicians.
WARNING: Do not apply power to the drive tray assembly when it is
not installed in the library.
4473D
DLT Drive Tray Assembly
3–13