Dell PowerVault 130T DLT Service Manual page 33

PowerVault 130T Service Manual
WARNING: Do not power down or reset the library while in the writing
mode.
6. When the library Operator Panel displays Write OK...<Reset>, push the
Reset button on the operator panel.
7. The library will reboot and the operator panel will display:
8. At the DOS prompt, type flash97.exe boot.prm
The program will then prompt you for the serial port number. Type in the
serial port number that is connected to the cable and press ENTER.
The PC displays Sending and the library Operator Panel displays
Receiving.
Next, the PC displays Send Status: File transfer completed
successfully. The library Operator Panel displays Writing.... .
WARNING: Do not power down or reset the library while in the writing
mode.
9. When the library Operator Panel displays Write
Reset button on the operator panel.
10. During boot, while the library display reads <Menu> Available (visible
for about five seconds), press the MENU button on the operator panel.
11. The operator panel displays the choices
Select Functional Reflash using the arrow buttons and press ENTER
The operator panel displays
12. At the DOS prompt, type flash97.exe release.prm
The program will then prompt you for the serial port number. Type in the
serial port number that is connected to the cable and press ENTER.
The PC displays Sending and the library Operator Panel displays
Receiving
Next, the PC displays Send Status: File transfer completed
successfully. The library Operator Panel displays Writing.....
WARNING: Do not power down or reset the library while in the writing
mode.
4473D
BOOT RE–FLASH
APPLICATION RUNNING
Connect CSE Port...
>Functional Reflash
NVRAM test & init
Connect CSE port...
Important Procedures
OK...<Reset>, push the
2–11