Table of Contents
Advertisement
PowerVault 130T Service Manual
Removal
1. Try to view the library configuration
information by accessing Library Utilities
from the Operator Panel menu and
selecting View Configuration.
2. Manually log all of the configuration
information, including library SCSI ID,
tape drive SCSI IDs, etc.
3. Remove the electronics module following
the procedures beginning on page 3–20.
4. Disconnect cables J41, J42, J44, and J15S
or D from their connectors. Refer to
Figure 3–3 for connector locations.
5. Remove the 18 screws attaching the CYC
card to the standoffs on the electronics
module chassis using a Torx driver with a
T-10 bit.
Replacement
1. Remove the new CYC card from its
packaging.
2. Align the card with the 18 standoffs on the
electronics module chassis.
3. Install the 18 screws attaching the CYC
card to the EM chassis using a Torx driver
with a T-10 bit.
4. Connect cables J41, J42, J44, and J15 S or
D to their connectors. Refer to Figure 3–3
for connector locations.
5. Replace the electronics module following
the procedure beginning on page 3–23.
6. Reconfigure the new CYC card using the
information you obtained from the View
Configuration menu in step 1 of the
removal procedure above.
NOTE: Refer to Chapter 2 for instructions about setting library and tape drive SCSI IDs. A
detailed configuration procedure is available in the PowerVault 130T User's Guide.
4473D
CYC Card
3–7
Advertisement
Table of Contents
