PowerVault 130T Service Manual
Figure 1–3.
Rear View of the PowerVault 130T Library
The locations below are described as you face the rear of the library:
Hinged Access Door
DLT Drive
SCSI Connectors
CYC Card
Electronics Module
Debug Connector
CSE Connector
Fans
AC Power Receptacle
4473D
The hinged access door is between the electronics
module and the drive slots. Drive and CYC card
cables and connectors are accessed through it.
DLT tape drives are in the drive slots on the left.
Small Computer Systems Interface (SCSI)
connectors are at the top right, beside the power
switch on the electronics module (EM).
The CYC card is mounted inside, on the EM.
The electronics module is on the right side. It
houses the power supply, CYC card, and two fans.
For engineering use only The debug connector is
between the fans; left of the CSE connector.
The CSE connector is between the fans; right of
the debug connector.
The fans are mounted to the electronics module.
The AC power receptacle is on the lower right, on
the electronics module.
Component Locations
1–3