Dell PowerVault 130T DLT Service Manual page 47

PowerVault 130T Service Manual
Replacement
Magnetic Sensor Replacement
1. Push the magnetic sensor switch through
the cutout as shown.
2. Connect the magnetic sensor connector.
CYO Card Replacement
3. Align the four screw holes in the CYO
card with the screw holes in the operator
panel enclosure.
NOTE: Make sure the trace side of the card
is facing you and that the component side
is down. The operator panel display must
align with the cutout in the operator panel
enclosure.
4. Install the four CYO card screws using a
Torx driver with a T-10 bit.
4473D
CYO Card
3–11