Dell PowerVault 130T DLT Service Manual page 53

PowerVault 130T Service Manual
CAUTION: When sliding the drive into
its bay, make sure the tape drive
interface cable (with connectors
P980-P983) is out of the way. Do not
force the tape drive into the drive slot.
8. Slide the drive into its slot, being careful
not to catch or crush any cables.
9. Tighten the two thumbscrews on the back
of the drive assembly.
CAUTION:
Before connecting the external
SCSI cables, make sure there is no
activity on the SCSI bus. Do not
connect to a hot bus.
Any third party software must be
quiesced.
All signals must be terminated at
each end of the SCSI bus. Do not
mix single-ended and differential
terminators.
10. Connect the SCSI cables and/or terminator
to the SCSI connectors on the rear of the
tape drive.
CAUTION: The tape drive interface
cable (P980-P983) marking faces the
rear of the tape drive. Note this
orientation when reinstalling. The
connector is keyed but it is still
possible to insert it incorrectly.
11. Connect the tape drive interface cable to
the tape drive interface connector on the
tape drive.
The connectors are numbered:
P980 – Drive 3
P981 – Drive 2
P982 – Drive 1
P983 – Drive 0
4473D
DLT Drive Tray Assembly
3–17