Dell PowerVault 130T DLT Service Manual page 45

PowerVault 130T Service Manual
Removal
1. Review the information under
"Preparation" at the beginning of this
chapter before starting this procedure.
2. Power off the library. Refer to "Powering
On and Off the Library" on page 3–2.
3. Unlock and open the library front door.
Refer to "Opening/Closing/Removing the
Library Front Door" on page 3–3.
CAUTION: Do not drop the Keps nuts into the library.
4. Remove the two bottom Keps nuts on the
op panel.
5. Loosen, but do not remove the two top
nuts.
6. Pull the bottom of the op panel forward to
disengage the top two flanges.
7. Allow the op panel cover to tilt forward to
provide access to the rear of the op panel.
8. Disconnect P240 connector on the ribbon
cable.
9. Disconnect P1 power cable.
4473D
CYO Card
3–9