Dell PowerVault 130T DLT Service Manual page 56

Electronics Module
Removal
1. Review the information under
"Preparation" at the beginning of this
chapter before starting this procedure.
2. Power off the library. Refer to "Powering
On and Off the Library" on page 3–2.
3. Try to view the library configuration
information by accessing Library Utilities
from the Operator Panel menu. Then
select View Configuration.
4. Manually log all of the configuration
information, including library SCSI ID,
tape drive SCSI IDs, etc.
5. Disconnect the SCSI connectors from the
electronics module.
6. Disconnect the AC power cable from the
electronics module.
7. Remove the four screws from the top and
bottom of the electronics module using a
Torx driver with a T-15 bit.
8. Loosen the three thumbscrews on the
hinged access door at the rear of the
library.
9. Open the door.
3–20
PowerVault 130T Service Manual
4473D