Disconnecting The Pcx-T Module - HP Model 715/100XC - Workstation Handbook

Use a small flatblade screwdriver to press in one of the two notched snap tabs on the
carrier, as shown in Figure 5–43. At the same time, use another flatblade screwdriver
to gently pry the PCX-T board at the corner edge nearest the snap tab to loosen it
from its connection on the processor board. Repeat this sequence for the second tab
on the carrier.
Gently Pry Board
Up
Notched Snap Tab
Figure 5–43. Disconnecting the PCX-T Module
Notched Snap Tab
Field Replaceable Units
5–43