HP Model 715/100XC - Workstation Handbook page 54

The workstation is now searching for devices that may hold file systems from
which it can boot HP–UX. As they are found, they appear in a list similar to
the following example:
Device Selection
Device Type
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
P0
QUANTUM LPS525s
P1
QUANTUM LPS525s
P2
TOSHIBA CD–ROM DRIVE:XM
14. The following list of actions appears:
b) Boot from specified device
s) Search for bootable devices
a) Enter boot administration mode
x) Exit and continue boot sequence
?) Help
Select from menu:
Press a
Return
The following prompt appears:
BOOT_ADMIN>
15. Set the default console to the CRX graphics option by entering the following
command line:
BOOT_ADMIN>
16. Enter the following command:
BOOT_ADMIN>
17. Power off the workstation and the monitor.
18. Connect the color monitor to the CRX graphics connector as shown in Chap-
ter 1 of this manual. Connect the second monitor to the built–in graphics
connector on the rear of the workstation, as shown in Chapter 1. For Model
715/C, 715/33, 715/50, and 715/75 workstations, check the workstation's
graphics configuration switches, as shown in earlier in this chapter, to make
sure the graphics switches are set correctly for the second monitor.
19. Power on the monitors and the workstation.
Device Path
scsi.6.0
scsi.5.0
scsi.2.0
path console graphics_2
exit
Return
Return
Configuration 3–23