Installing Memory Boards - HP Model 715/100XC - Workstation Handbook

Install the new memory board with its top edge tilted about 45 toward the front of
the system unit. Note that the memory board is notched on one end to fit the keyed
connector. Press firmly on the memory board to ensure that it is fully seated. Snap
the board into place by moving it to a vertical position. Its ends snap into the connec-
tor's spring clips. Figure 5–41 shows how to install the memory board.
See the memory configuration rules described in Chapter 3 if you are changing the
memory configuration.
Figure 5–41. Installing Memory Boards
5–41
Field Replaceable Units