Configuring The Crx Graphics Options; Setting Up A Single Monitor System - HP Model 715/100XC - Workstation Handbook

Configuring the CRX Graphics Options

This section describes how to configure the system to use the CRX graphics options
(if installed).
For information about HCRX graphics, refer to the HP A4070A/A4071A/A4072A CE
Handbook (A4070–90099).
If you update or reinstall HP–UX, and after a few minutes, there is no output on the
monitor, use the following procedures to configure the workstation:
1. Power off the workstation.
2. Connect the monitor to the built–in graphics connector as shown in Chapter 1
of this manual.
3. For Model 715/C, 715/33, 715/50, and 715/75 workstations, check the
workstation's graphics configuration switches, as shown earlier in this chap-
ter, to make sure the graphics switches are set correctly for the monitor.
4. Power on the monitor and the workstation.
5. Immediately after you power on the workstation, press the TOC switch on
the right side of the system unit. (See Chapter 1 of this manual for the TOC
switch location.)
6. If you are setting up a single monitor system, follow the steps in the next
subsection. If you are setting up a dual monitor system, go to the subsection
"Setting Up a Dual Monitor System" for further configuration instructions.

Setting Up a Single Monitor System

This subsection describes how to set up the workstation to use only the CRX graph-
ics.
NOTICES:
1. Log in as root.
2. Enter the following command line to create a device file to support the CRX
graphics:
/etc/mknod /dev/crt24 c 12 0x100000
3–18 Configuration
Only the 20–inch color monitors are supported on the
CRX graphics adapters.
The built–in graphics adapter can use any of the sup-
ported monitors.
Return