Removing And Replacing The Dds-Dc Drive; Adding Or Removing The Dds-Dc Drive Bezels And Expansion Brackets - HP Model 705 - Workstation User Manual

Troubleshooting and Removal/Replacement Procedures

Removing and Replacing the DDS-DC Drive

To open your system and to remove and reinstall the DDS-DC drive, refer to the owner's
guide that came with your system. Read "Preparing to Install the DDS-DC Drive" in
Chapter 1 of this guide before beginning an installation.

Adding or Removing the DDS-DC Drive Bezels and Expansion Brackets

Depending on the size of the drive opening in your system, you may need to add or
remove a bezel or expansion brackets to ensure that your DDS-DC drive fits in your
system.
NOTICE: Before performing any of these changes, make sure there is not a
cassette in the drive.
To add a bezel (it can be a 3.5-inch bezel, or a 5.25-inch bezel) to your drive,
push onto the drive, making sure the tabs click into place. Refer to Figure 3–1.
To remove a bezel from a drive, use a straight blade screwdriver to lift the bezel
tabs from the sides of the drive. Refer to Figure 3–2.
To add or remove expansion brackets to the drive, use a T10 torx wrench to ei-
ther tighten or remove the four torx screws that hold each expansion bracket to
the drive. Refer to Figure 3–3.
3–10