HP Model 705 - Workstation User Manual page 41

2.
Attach the static-grounding wrist strap by following the instructions on the package
that contains the strap.
3.
Shut down HP-UX.
NOTICE: If you are already at the boot administration level, you do not need
to shut down; skip this step and go on to Step 4.
If you are running HP-UX under HP VUE, shut down your system by performing
the shutdown procedure described in the owner's guide that came with your work-
station.
If you are running HP-UX without HP VUE, shut down your system by typing the
following command:
# /etc/shutdown -h
You must have superuser privileges to use the /etc/shutdown command. If you do
not have superuser privileges, contact your system administrator.
If your workstation is part of a cluster, refer to Managing Clusters of HP 9000 Com-
puters for instructions on shutting down.
4.
Power off the workstation, using the power switch on the front of the workstation.
CAUTION: Do not power off your workstation without first shutting down
HP-UX. Powering off with HP-UX still running could damage
the data on the disks associated with your workstation.
5.
Remove the drive and check the jumpers, as described in "Removal/Replacement
Procedures" at the end of this chapter.
6.
Replace the drive.
7.
Check the cable connections of your DDS-DC drive. Make sure that the connectors
are aligned and seated correctly.
Troubleshooting and Removal/Replacement Procedures
RETURN
3–5