Preparing The System - HP Model 705 - Workstation User Manual

Preparing the System

Perform the following steps to prepare the system for the DDS-DC drive installation:
1.
Determine the existing SCSI-2 address settings currently in use on your system by
completing the following steps.
2.
If you are using HP-UX 9.X, enter the following at the prompt:
/etc/ioscan
After a few moments the ioscan utility lists all of the I/O devices it could find. If
there is a SCSI DDS drive in the list, its listing appears similar to the following:
H/W Path
==============================================
2.0.1.3.0
If you are using HP-UX 10.X, enter the following at the prompt:
/usr/sbin/ioscan
After a few moments the ioscan utility lists all of the SCSI I/O devices it could find.
The list appears similar to the following:
RETURN
Description
tape drive
RETURN
Introduction
Status
ok(nnnnnnnn)
1–11