Preparing To Install The Dds-Dc Drive; Tools Required; Verifying Kit Contents; Operating System Support - HP Model 705 - Workstation User Manual
Hp dds-dc tape drive user's guide (a1658-90696)
Hide thumbs
Also See for Model 705 - Workstation:
- User manual (62 pages) ,
- Notice (2 pages) ,
- User reference (84 pages)
Table of Contents
Advertisement
Introduction
Preparing to Install a New DDS-DC Drive
The following information describes how to prepare the DDS-DC drive for installation.
Tools Required
The following tools are needed to install the DDS-DC drive:
#2 Phillips screwdriver
Small needlenose pliers
T10 torx wrench
Verifying Kit Contents
Verify that the kit contains one of each of the following:
DDS-DC drive (part number 0950–3002) and bezel.
Set of 4 screws (M4x6)
Power adapter cable
SCSI I/O cable
Static strap
HP DDS-DC Tape Drive User's Guide (A1658–90696)
NOTICE:
If any contents of your kit are missing, contact your sales
representative.
Operating System Support
The HP DDS-DC drive supports HP-UX 9.01 and later. This drive does not require any
patches.
1–6
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Model 705 - Workstation and is the answer not in the manual?
Questions and answers