Toshiba PSA10C-035WM Maintenance Manual page 268

4 Replacement Procedures
Installing the Wireless LAN Antenna/Display Cover/Speaker
The following describes the procedure for installing the wireless LAN antenna, display cover,
and display cable (See Figure 4-37 to 4-44).
1. Install the hinges to the display assembly and secure them with the following screws.
• M2.5x6
• M2.5x5
2. Install the left and right speaker nets and bend the edges (at four points each) using a
device such as a flatblade driver and secure them.
3. Install the display cover to the display assembly.
4. Open the display at 45-degree slant and secure the hinges to the display cover with
the following screws.
• M2.5x2.8
5. Secure the hinges to the display cover with the following screws. Stick two mask
seals on each side of the display cover.
• M2.5x2.8
• M2.5x6
6. (For wireless LAN models only)
Fit the wireless LAN antennas to the grooves at the rear of the display cover with
double-sided adhesive tapes. Set the wireless LAN antenna cables and stick four
acetate tapes on the cables.
7. (For wireless LAN models only)
Pass the wireless LAN antenna cables through the bottom of the display cover toward
the back side of the display assembly.
8. Pass the LCD cable from the bottom of the display cover toward the back side of the
display assembly. Then install the LCD cable holder and secure the holder with the
following screw.
• M2.5x4
9. Turn the display assembly face down. Close the display and attach the hinge cover.
Then open the display and secure two latches of the hinge cover. Turn the display
assembly face down and secure the hinge cover with the following screw.
• M2.5x4
4-62
4.17 Wireless LAN Antenna/Display Cover/Speaker
PSP TIGHT screw
THIN BIND screw
THIN BIND screw
THIN BIND screw
THIN BIND screw
PSP TIGHT screw
PSP TIGHT screw
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
x3 (Left: 2, Right:1)
x1 (Right)
x2
x4 (Display cover side)
x2 (FL inverter side)
x1
x1