Toshiba PSA10C-035WM Maintenance Manual page 219

4.3 Memory Module
4. Open the left and right latches and remove the memory module.
Latch
SLOT A: Standard Memory
Installing the memory module
To install the memory module, confirm that the computer is in boot mode. Then perform the
following procedure (See Figure 4-4, 4-5).
1. Insert the memory module into the connector of the computer slantwise (terminal side
first) and press it to connect firmly.
CAUTION: The power must be turned off when you insert the memory module. Inserting
a memory module with the power on might damage the module or the computer
itself.
Never press hard or bend the memory module.
2. Install the memory slot cover and secure it with the supplied screw.
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, make sure it is connected surely.
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
SLOT B: Expansion Memory
Figure 4-5 Removing Memory Module
4 Replacement Procedures
Latch
Memory Module
4-13