Serial Port Settings; Ip Address - D-Link DGS-3200-16 - Switch - Stackable User Manual

xStack

Serial Port Settings

The user can adjust the Baud Rate and the Auto Logout values.
To view the following window, click Configuration > Serial Port Settings:
Baud Rate
Auto Logout
Click Apply to implement changes made.

IP Address

The IP address may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP
address has not yet been changed, read the introduction of the DGS-3200 Series CLI Manual for more information. TheWeb
manager will display the Switch's current IP settings.
To view the following window, click Configuration > IP Address:
To manually assign the Switch's IP address, subnet mask, and default gateway address:
1. Click the Manual radio button at the top of the window.
2. Enter the appropriate IP Address and Subnet Mask.
3. If accessing the Switch from a different subnet from the one it is installed on, enter the IP address of the default Gateway.
If managing the Switch from the subnet on which it is installed, the user may leave the default address (0.0.0.0) in this
field.
4. If the Switch has no previously configured VLANs, the user can use the Management VLAN Name entitled "default".
This default Management VLAN contains all of the Switch ports as members. If the Switch has previously configured
VLANs, the user will need to enter the VLAN ID of the VLAN that contains the port connected to the management
station that will access the Switch. The Switch will allow management access from stations with the same VID listed
here.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 2- 3. Serial Port Settings window
This field specifies the baud rate for the serial port on the Switch. There are four possible
baud rates to choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch
using the CLI interface, the baud rate must be set to 115200, which is the default setting.
Select the logout time used for the console interface. This automatically logs the user out after
an idle period of time, as defined. Choose from the following options: 2 mins, 5 mins, 10 mins,
15 mins or Never. The default setting is 10 mins.
Figure 2- 4. IP Address window
6