D-Link DGS-3200-16 - Switch - Stackable User Manual page 174

xStack
rate is 640kbit/sec.) The user many select a value between 1 and 156249 or tick the No Limit
check box. The default setting is No Limit.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this access rule
Name
will be implemented on the Switch.
Ports When a range of ports is to be configured, the Auto Assign check box MUST be ticked in the
Access ID field of this window. If not, the user will be presented with an error message and the
access rule will not be configured. Ticking the All Ports check box will denote all ports on the
Switch.
To view the settings of a previously correctly configured rule, click the corresponding Show Details button on the Access Rule
List window to view the following window:
To establish the rule for a previously created Access Profile:
To configure the Access Rules for IPv4, open the Access Profile List window and click Add/View Rules for an IPv4 entry. This
will open the following window:
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 18. Access Rule Detail Information window for IPv6
Figure 6 - 19. Access Rule List window for Packet Content
161