D-Link DGS-3200-16 - Switch - Stackable User Manual page 187

xStack
To set the Access Rule for IPv6, adjust the following parameters and click Apply.
Parameter Description
Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100.
Action Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Flow Label Configuring this field, in hex form, will instruct the Switch to examine the flow label field of the
IPv6 header. This flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets..
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
Name configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Ports Ticking the All Ports check box will denote all ports on the Switch.
To view the settings of a previously correctly configured rule, click the corresponding Show Details button on the CPU Access
Rule List window to view the following window:
To establish the rule for a previously created CPU Access Profile:
To configure the Access Rules for IP, open the CPU Access Profile List window and click Add/View Rules for a Packet Content
entry. This will open the following window.
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 39. CPU Access Rule Detail Information window for IPv6
Figure 6 - 40. CPU Access Rule List window for Packet Content
174