Table of Contents
Advertisement
iLO Switch (SW2)
The iLO switch is a four-position switch that grants you access to perform a boot
block flash of system ROM and iLO ROM. For the proper system configuration
switch settings, refer to Table E-4 or refer to the labels attached to the inside of the
server access panel.
Table E-4: iLO Switch (SW2) Settings
Position
1
2
3
4
System Switch (SW3)
The function for this switch is reserved.
CAUTION: Do not change any SW3 settings or the system may not function
properly.
System Configuration Switch (SW1)
The system configuration switch is a four-position switch that enables access to
server hardware settings. The default setting for all four positions is off. For the
proper system configuration switch settings, refer to Table E-5 or refer to the labels
attached to the inside of the server access panel.
Compaq ProLiant BL20p Server Blade Setup and Installation Guide
Description
Reserved
ILO security
override
Reserved
Reserved
On/Off Function
—
Off = iLO security is enabled; iLO
access requires a valid user ID and
password. Also, the iLO boot block
access is disabled and the iLO boot
block cannot be flashed.
On = iLO security is disabled; iLO
access is possible without a valid user
ID or password. Also, the iLO boot
block access is enabled and the iLO
boot block can be flashed.
—
—
LEDs and Switches
E-9
Advertisement
Table of Contents
