Table of Contents
Advertisement
Power On/Standby Button
Setting the server blade Power On/Standby button to the standby position removes
power from most areas of the server blade. This process may take 30 seconds, during
which time some internal circuitry remains active.
IMPORTANT: To remove power completely, remove the server blade from the server blade
enclosure.
Use Figure E-3 to identify the button location.
Figure E-3: Power On/Standby button
System Switches
System switches enable you to change certain settings or to perform advanced
diagnostic procedures. Use Figure E-4 and Table E-3 to identify switch locations and
functions.
Compaq ProLiant BL20p Server Blade Setup and Installation Guide
LEDs and Switches
E-7
Advertisement
Table of Contents
