Stacker Mappings Functions; Host Specified Stacking / Printer Specified Stacking - Xerox 6100BD - Phaser Color Laser Printer User Manual

Using Xerox FreeFlow® Print Server IPS Manager

Stacker Mappings Functions

3- 1 2
3. Assign the stock to two different virtual trays.
4. Set the Tray Type for one virtual tray containing the stock to
Inserter.
5. Set the Tray Type for the other Virtual Tray containing the
stock to Fuser.
As in other cases, once the setup for an Inserter Bin job has been
created, it is helpful for a System Administrator, or other expert, to
store the initial mapping in a job setup profile, which can then be
invoked by the operator, when the application must be run again.
The Stacker Mappings tab shows what physical output
destinations are assigned to the virtual IPDS Output Bins that are
reported to the host. The Job Profile Editor provides the following
capabilities:
• Map IPDS Bins to Stackers: Designates how individual virtual
bins correspond to specific output destinations. The IPS
Manager presents from at least 5 virtual bins to as many
virtual bins as there are physical stackers in the system.
• Host Specified Stacking: Maps the virtual bins recognized by
the host to the specific physical output destinations on the
printer. If an IPDS job includes the commands, individual
sheets can be directed to specific output destinations as
specified by the IPDS job. This allows for greater control for
output delivery of portions of an IPDS job or between different
IPDS jobs.
• Printer Specified Stacking: Allows the system to perform
automatic stacking, ignoring any commands for output
destinations contained within the IPDS job. Automatic
stacking causes the system to direct the output to a suitable
stacker. If Unload While Run is supported by the printer,
Printer Specified Stacking allows you to unload one bin while
the printer continues to deliver sheets to another bin.

Host Specified Stacking / Printer Specified Stacking

The Host Specified Stacking selection causes the print server to
determine where to deliver each sheet by mapping the virtual bin
requested by the host to a specific physical stacker on the printer,
as selected in the Map IPDS Bins to Stackers panel in the Stacker
Mappings dialog. This involves some setup, depending upon the
number and type of stackers available on the system.
The Printer Specified Stacking selection causes the print server to
determine where sheets will be stacked, without using the virtual
bin to physical stacker mappings. If you select Printer Specified
IPDS User Guide