Nonport Side Of The 8/40 San Switch; Activating Additional 8/40 San Switch Ports; 8/80 San Switch Features; Nonport Side View-8/40 San Switch - HP StorageWorks 8/24 - SAN Switch Hardware Reference Manual

Nonport side of the 8/40 SAN Switch

The nonport side includes the two redundant power supply fan assemblies and the corresponding status
LEDs. Figure 3
1
1. Fan (for power supply/fan FRU2)
2. Power supply/fan status LED (for power supply/fan
FRU2)
3. Power supply connector (for power supply/fan
FRU2)
4. Fan (for power supply/fan FRU2)
Figure 3 Nonport side view—8/40 SAN Switch

Activating additional 8/40 SAN Switch ports

By default, the 8/40 SAN Switch model integrates 24 licensed ports (ports 0 through 23). To enable
additional ports, you must purchase and install the HP Storage Works 8/40 SAN Switch 8Gb 8-port
Upgrade LTU (part number T5519A):
• To enable ports 24 through 31, you must purchase and install one upgrade license.
• To enable ports 32 through 40, you must purchase and install a second upgrade license.
See Installing and activating Port Upgrade

8/80 SAN Switch features

• Provides the EZSwitchSetup Wizard for easy setup and basic configuration.
• Integrates 1, 2, 4, and 8Gb/s autosensing Fibre Channel switch and router ports.
• Includes a system motherboard that features a Freescale MPC8548 Reduced Instruction Set
Computer (RISC) CPU running @ 1.3GHz with integrated peripherals that provides high
performance with low power consumption.
• Ships FICON, FICON Cascading, and FICON Control Unit Port (CUP) ready.
• Provides two hot-swappable, redundant power supply FRUs.
• Provides three hot-swappable fan FRUs in an N+1 configuration to provide hardware-redundant
cooling.
• Provides universal ports that self-configure as E_Ports, F_Ports, M_Ports, or FL_Ports. Ex_Ports are
activated on a per-port basis with the optional HP B-series 48-80 Port SAN Switch Integrated
Routing LTU. This license provides native Fibre Channel Routing (FCR) on a per-port basis, rather
than limiting routing ports to those on a dedicated routing blade or switch. Just like traditional
FCR, Integrated Routing uses EX_Ports to import and export devices between fabrics, enabling
selective device sharing while maintaining remote fabric isolation. See
ordering information.
• Integrates a Universal Serial Bus (USB) port that provides storage for firmware updates, output of
the supportsave command and storage for configuration uploads and downloads.
shows the nonport side of the 8/40 SAN Switch.
2 3 4 5 6 7
5. Fan (for power supply/fan FRU1)
6. Power supply/fan status LED (for Power Supply/fan
FRU 1)
7. Power supply connector (for power supply/fan
FRU 1)
8. Fan (for power supply/fan FRU1)
licenses, page 20.
8Gb SAN Switch hardware reference manual
8
26451a
Table 5, page 23 for
17