Push down on the hood latch. The access panel slides to a closed position.
2.
Use the T-15 Torx screwdriver provided with the server to tighten the security screw on the hood latch.
3.
Remove the air baffle
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
Remove the air baffle.
5.
Install the air baffle
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
For proper cooling, do not operate the server without the access panel, baffles,
For proper cooling, do not operate the server without the access panel, baffles,
Operations 22