Table of Contents
Advertisement
Remove the air baffle (on page 22).
5.
Remove the PCI riser cages (on page 23).
6.
Connect the two-port SATA cable:
7.
Connect the cable to the drive sideband signal connector.
a.
Secure the cable in the cable clip.
b.
Connect the cable to the SATA storage and optical drive connectors.
c.
Route the cable along the side of the system board towards the front chassis, and then connect the
d.
cable to the drive backplane.
LFF drive
o
SFF drive
o
Connect the rest of the drive cables required in this drive configuration. For more information, see
8.
"Storage cabling (on page 82)."
Install the PCI riser cages (on page 24).
9.
Install the air baffle (on page 22).
10.
Install the access panel (on page 21).
11.
Hardware options installation 44
Advertisement
Table of Contents
