Install the access panel (on page 28).
6.
Install the server into the rack
7.
Connect each power cord to the server.
8.
Connect each power cord to the power source.
9.
Power up the server
10.
Secure the full-length expansion board retainer
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 26).
3.
Remove the access panel (on page 27).
4.
Install a full-length expansion board
5.
Install the PCI riser cage (on page 31).
6.
Secure the full-length expansion board retainer.
7.
Install the access panel (on page 28).
8.
Install the server into the rack
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server
12.
Remove the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
To remove the component:
Power down the server (on page 26).
1.
("Installing the server into the
("Powering up the
server" on page 26).
("Installing an expansion
("Installing the server into the
("Powering up the
server" on page 26).
rack" on page 39).
board" on page 118).
rack" on page 39).
Operations 32