Table of Contents
Advertisement
Install the fan module into the fan bay.
5.
Install the access panel (on page 21).
6.
Slide the server back into the rack.
7.
If the fan installation was made to upgrade the server from a nonredundant to a redundant fan mode,
8.
reboot the server.
Installing the hot-plug fan module if the server is installed in a
friction rail system
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 20).
3.
Remove the access panel (on page 21).
4.
Do one of the following:
5.
Hardware options installation 55
Advertisement
Table of Contents
