Table of Contents
Advertisement
•
Each channel can have a different valid online spare configuration.
•
Each populated channel must have a spare rank:
A single dual-rank DIMM is not a valid configuration.
o
LRDIMMs are treated as dual-rank DIMMs.
o
Installing a DIMM
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
Remove the air baffle (on page 22).
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the air baffle (on page 22).
8.
Install the access panel (on page 21).
9.
Install the server into the rack
10.
Power up the server (on page 18).
11.
After installing the DIMMs, use RBSU
protection mode.
("Installing the server into the
("HP ROM-Based Setup
rack" on page 31).
Utility" on page 103) to configure the memory
Hardware options installation 63
Advertisement
Table of Contents
