Table of Contents
Advertisement
Fan population guidelines
Configuration
One processor,
nonredundant
One processor, redundant
Two processor, nonredundant Fan
Two processor, redundant
Installing a hot-plug fan module if the server is installed in a
ball-bearing rail system with the cable management arm
CAUTION:
functioning server has all feature bays populated with the required component or blank and the
access panel is installed within 60 seconds of being serviced.
Pull down the quick release levers on each side of the server.
1.
WARNING:
adequately stabilized before extending a component from the rack.
Extend the server on the rack rails until the server rail-release latches engage.
2.
If the server does not extend from the rack, use a T-25 Torx screwdriver to loosen the screws located
within the lever housing.
Open the latch, slide the access panel to the rear of the chassis, and then remove the access panel.
3.
If the latch is locked, use a T-15 Torx screwdriver to unlock the latch.
Do one of the following:
4.
Fan bay 1
Fan bay 2
Blank
Fan
Fan
Fan
Fan
Fan
Fan
To prevent the potential for thermal damage and system shutdown, ensure that a
To reduce the risk of personal injury or equipment damage, be sure that the rack is
Fan bay 3
Fan bay 4
Blank
Fan
Blank
Fan
Fan
Fan
Fan
Fan
Hardware options installation 53
Fan bay 5
Fan bay 6
Fan
Fan
Fan
Fan
Fan
Blank
Fan
Fan
Advertisement
Table of Contents
