Table of Contents
Advertisement
If you are not installing the secondary PCI riser cage, then install the secondary PCI riser cage blank.
10.
Connect the rest of the drive cables required in this drive configuration. For more information, see
11.
"Storage cabling (on page 82)."
Install the drives
12.
CAUTION:
all bays are populated with either a component or a blank.
Install the access panel (on page 21).
13.
Install the server into the rack
14.
Power up the server (on page 18).
15.
Drive cable options
Two-port SATA cable
When the two-port SATA cable option is installed in the 8-bay drive cage, the server supports the 6-drive
SATA configuration. In this configuration, drive bays 1 through 6 are populated, while drive bays 7 and 8
contain drive blanks.
To connect the cable option:
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
("Drive
options" on page 34).
To prevent improper cooling and thermal damage, do not operate the server unless
("Installing the server into the
rack" on page 31).
Hardware options installation 43
Advertisement
Table of Contents
