Remove The Air Baffle - HP ProLiant DL388p User Manual

Secure the full-length expansion board retainer.
7.
Install the access panel (on page 23).
8.
Install the server into the rack
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server (on page 21).
12.

Remove the air baffle

CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server (on page 21).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend or remove the server from the rack
3.
Remove the access panel (on page 22).
4.
CAUTION:
Detaching the cable causes any unsaved data in the cache module to be lost.
IMPORTANT:
board installed.
("Installing the server into the
For proper cooling do not operate the server without the access panel, baffles,
Do not detach the cable that connects the battery pack to the cache module.
It is necessary to remove the PCI riser cage only if there is a full-length expansion
rack" on page 35).
("Extend the server from the rack" on page 21).
Operations 29