Installing The Integrated Array Bypass - HP DL740 - ProLiant - 4 GB RAM User Manual

Installing Hardware Options, Non-Hot-Plug

Installing the Integrated Array Bypass

Use the Integrated Array Bypass kit to bypass the Smart Array 5i Controller and use
an optional controller.
The Smart Array 5i Controller is routed to the internal drives through the Array
Enabler board in the host module.
The Integrated Array Bypass kit allows you to replace the Array Enabler board with a
connector and cable that you can connect to an optional controller board.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Back up the data each time that you move drive arrays or change the
configuration.
To install the Integrated Array Bypass:
1. If you have not powered up your server for the first time, skip to step 4. If you
have powered up your server, back up your server data.
2. Shut down the operating system as directed in your operating system instructions.
3. Power down the server (refer to Chapter 7).
4. Disconnect the power cords from the server.
5. Slide the server out of the rack.
4-12 HP ProLiant DL740 Server User Guide