HP DL740 - ProLiant - 4 GB RAM User Manual page 199

Using ORCA
To configure the drive array controller:
1. If you have any previously used hard drives installed in the server, select View
Logical Drive, and then press the Enter key to view the configuration of the
drives. If you do not see any logical drives configured, press the Esc key to
return to the ORCA Main Menu, and then proceed to step 2.
If you do see an existing logical drive or drives:
a. Press the Esc key to return to the Main Menu.
b. From the Main Menu, select Delete Logical Drive. The Delete Logical
Drive screen is displayed.
c. Follow the instructions on the screen to delete the logical drive or drives.
After the drives have been deleted, you will be returned to the Main Menu.
2. Select Create Logical Drive, and then press the Enter key.
3. Follow the screen prompts to define the RAID configuration. For more
information about configuring your specific array controller, refer to the
documentation that came with your array controller, or refer to the HP website:
www.hp.com/support/storage/index.shtml
From this website, click Array and SCSI controllers, and then navigate to the
appropriate controller information.
4. When you have finished configuring the array, press the Esc key to exit ORCA.
HP ProLiant DL740 Server User Guide
CAUTION: If you have installed any previously-used hard drives into the
ProLiant DL740 server, you must delete any array configuration information that
those drives contain. Doing so destroys any data on those hard drives.
Configuring the Server
8-19