Hot-Plug Redundant Power Supply/Pci Switch (Sw1) Settings; Debug Led Switch (Sw3) Settings - HP DL360 - ProLiant - G3 Setup And Installation Manual

LEDs, Switches, and Jumpers

Hot-Plug Redundant Power Supply/PCI Switch (SW1) Settings

The hot-plug redundant power supply/PCI switch (SW1) is a four-position switch
used for system maintenance. Refer to the labels attached to the inside of the server
access panel for the proper switch settings. The following table shows the shipping
configuration of SW1.
Table E-5: Hot-Plug Redundant Power Supply/PCI Install Switch (SW1) Settings
Position Function
S1 Reserved
S2 Reserved
S3 Reserved
S4 Identify PCI slot or Hot-Plug
Redundant Power Supply
support

Debug LED Switch (SW3) Settings

The Debug LED switch (SW3) is a four-position switch used for system
maintenance. The positions on this switch are currently reserved and are not modified
by the user.
E-8
Default
Off
Off
Off
Off
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Description
Reserved
Reserved
Reserved
Off = Normal (PCI slot 2 supported)
On = Hot-Plug Redundant power
supply installed