Installing The Redundant Hot-Plug Power Supply - HP ProLiant ML110 G7 Maintenance And Service Manual

Install the access panel
11.
Install the front bezel
12.
Power on the server.
13.

Installing the redundant hot-plug power supply

CAUTION:
all bays are populated with either a component or a blank.
Power down the server (on page 23).
1.
Remove the front bezel
2.
Remove the access panel
3.
Disconnect the power cables from the nonredundant power supply.
4.
("Installing the access
("Installing the front bezel" on page 25).
To prevent improper cooling and thermal damage, do not operate the server unless
("Removing the front
("Removing the access
panel" on page 24).
bezel" on page 25).
panel" on page 24).
Removal and replacement procedures 37