HP DL360 - ProLiant - G3 Setup And Installation Manual page 40

3. Loosen the thumbscrew (1) and remove the power supply blank (2).
Figure 2-16: Removing the power supply blank
4. Install the PCI blank in the chassis by inserting the rear tab of the PCI blank into
the opening on the chassis (1), then lowering the PCI blank into position (2), and
then tighten the thumbscrew (3).
Figure 2-17: Installing the PCI blank on the chassis
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
2-21