Installing The Server Board; Location Of The Mounting Screw Holes - Intel S845WD11U Product Manual

Installing the Server Board

Refer to your chassis manual for instructions on installing the server board. Eight screws secure the
server board to the chassis. Figure 7 shows the locations of the mounting screw holes.
✏
NOTES
You will need a Phillips (#2 bit) screwdriver.
Refer to Page 93 for regulatory requirements and installation instructions and
precautions.
WARNING
Only qualified technical personnel should attempt this procedure.
Disconnect the server from its power source before performing the
procedures described here. Failure to disconnect the power before you open
the server can result in personal injury or equipment damage.
46
Figure 7. Location of the Mounting Screw Holes
Intel Server Board S845WD1-E Product Guide
OM14283