Atapi Cdrom Drives Submenu; Exit Menu - Intel S845WD11U Product Manual

ATAPI CDROM Drives Submenu

To access this menu, select Boot on the menu bar, then ATAPI CDROM Drives.
Maintenance
The submenu represented in Table 34 is for setting ATAPI CDROM drive priority.
Table 34.

ATAPI CDROM Drives Submenu

Feature
st
1 ATAPI CDROM Drive
(Note)
Note: This boot device submenu appears only if at least one boot device of this type is installed. This list will display up to
four ATAPI CDROM drives, the maximum number of ATAPI CDROM drives supported by the BIOS.

Exit Menu

To access this menu, select Exit from the menu bar at the top of the screen.
Maintenance
The menu represented in Table 35 is for exiting the BIOS Setup program, saving changes, and
loading and saving defaults.
Table 35.

Exit Menu

Feature
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
Configuration Software and Utilities
Main Advanced
Options
Dependent on installed
ATAPI CDROM drives
Main Advanced
Description
Exits and saves the changes in CMOS SRAM.
Exits without saving any changes made in the BIOS Setup program.
Loads the factory default values for all the Setup options.
Loads the custom defaults for Setup options.
Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads the
custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discards changes without exiting Setup. The option values present when the
server was turned on are used.
Security Power
Description
Specifies the boot sequence from the available
ATAPI CDROM drives. To specify boot sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <Enter> to set the selection as the intended
boot device.
Security Power
Boot Exit
Boot Device Priority
Hard Disk Drives
Removable Devices
ATAPI CDROM Drives
Boot Exit
79