Optional For Hp Netserver Lh 3000R And Lh 6000R, Install Cable Management Arm - HP D7171A - NetServer - LPr Installation Manual

Chapter 3
Optional for HP NetServer LH 3000r and LH 6000r, Install
Cable Management Arm
The HP NetServer Cable Management Arm supplied with the HP LH 3000r and
LH 6000r allows the cables, including the power cord, to move in and out with the
HP NetServer chassis on its slides without being accidentally disconnected. See
Figure 3-8.
Rear of NetServer
Left Rear
Rack Column
Cable Management Arm
Figure 3-8. Attaching the Cable Management Arm
CAUTION
The cable management arm interferes with the rear door on
the Compaq rack. Before you install the cable management
arm, remove and discard the rear door from the Compaq rack.
1. Ensure that the HP NetServer is pushed all the way into the rack.
2. At the rear of the NetServer, place cage nuts on the left column in the 17th
and 18th holes above the baseline of the HP NetServer. See Figure 3-8.
16
Installation