Overview - HP D7171A - NetServer - LPr Installation Manual

2 Overview

The steps required to install the NetServer in the rack are summarized below:
NOTE
This is only a summary; detailed instructions are provided on the
following pages.
Measure and mark the appropriate holes on all four rack columns.
Install one bar nut on each of the four rack columns.
Insert two cage nuts on each of the two front columns only.
Attach the slides to the columns.
Extend the slides.
Remove power supply modules and hot-swap drives from the NetServer.
Lift the NetServer onto the slides.
Secure the NetServer to the slides.
Remove the lifting handles from the NetServer.
Reinstall the power supply modules and hot-swap drives.
Push the NetServer back into the rack enclosure.
For HP NetServer LH 3000r and LH 6000r, attach the optional cable
management arm.
Install the recessed mounting brackets on the two front columns only.
Relocate the control panel.
Install the Compaq rack-compatible bezel.
5