Installing The Netserver; Mounting The Netserver To The Slides - HP D7171A - NetServer - LPr Installation Manual

Chapter 3

Installing the NetServer

The NetServer now must be mounted to the slides, the cable management arm can
be installed, the recessed mounting brackets must be installed, the control panel
must be relocated, and the Compaq rack-compatible bezel must be installed.

Mounting the NetServer to the Slides

1. Extend the slides until you hear a click, indicating they are fully extended
in the locked-out position. Note that the slides do not come apart see
Figure 3-3.
WARNING To prevent the rack from tipping over, be sure that the
stabilizing, anti-tip feature is installed on this rack enclosure
see Figure 1-2.
2. Before you lift the NetServer, remove the power supply modules and the
hot-swap hard disk drives to reduce the weight.
WARNING
WARNING
Do not touch any metal object to the power supply connector
contacts. High Electrical charges may be stored in the module
even after it has been removed. Fire or bodily injury may
result if terminals are short-circuited.
12
The HP NetServer LH 3r weighs approximately
115 pounds (52 kg) after the hard disk drives and power
supply modules are removed. The HP NetServer LH 4r
weighs approximately 145 pounds (66 kg) after the hard
disk drives and power supply modules are removed.
The HP NetServer LH 3000r weighs approximately
118 pounds (54 kg) after the hard disk drives and power
supply modules are removed. The HP NetServer LH 6000r
weighs approximately 148 pounds (67 kg) after the hard
disk drives and power supply modules are removed
Do not attempt to lift the NetServer by yourself. Follow
local regulations when lifting the NetServer.
Failure to observe this warning could result in serious
injury to personnel or damage to equipment.
Installation